Omnitron Systems Technology Universal DIN Rail Mounting Bracket 8250-0 User Manual download pdf (Page 2)

[A] and [D]

[B]

[C]

Converter

Front Cover

Screw

[B], [C] and [D]

[A]

STEP 2. Optional Orientation Reconfiguration

If the desired mounting orientation is other than [B] as illustrated in Fig. 2,

remove the DIN Rail clips ( k ) from the bracket by removing the DIN Rail clip

screws ( m ). Determine the desired DIN Rail mounting orientation from the

Figure 2, and match the corresponding DIN Rail clip orientation in Figure 4.

Attach the DIN Rail clips ( k ) to the DIN Rail bracket holes in the DIN Rail

Bracket ( i ) and secure the DIN Rail clips ( k ) with DIN Rail clip screws ( m ).

Figure 4. Configuring Clip Mounting Orientation

STEP 3. Attaching Bracket to Converter

Remove the rear cover screws from the media converter casing. Align the

media converter to the bracket mounting holes that correspond with desired

orientation, then insert and fasten the supplied bracket mounting screws ( n )

to secure the media converter to the DIN Rail bracket ( i ).

Figure 5. Attaching Bracket to Converter

Form: 040-08250-001B 9/07

Patent Pending

DIN Rail

Cross Section

Close Up

Tab on the

DIN Rail Clip

Hooks on the

DIN Rail Clip

TECHNICAL SUPPORT:

For help with this product, contact our Technical Support:

Omnitron Systems Technology, Inc.

Phone: (949) 250-6510 Fax: (949) 250-6514

Address: 140 Technology Dr., #500 Irvine, CA 92618 USA

Email: [email protected]

URL: www.omnitron-systems.com

STEP 4. Mounting Converter to the DIN Rail

Attach the assembly to the DIN Rail, by aligning the hooks on the DIN Rail clip

( k ) to the upper edge of the DIN Rail. Rotate the assembly downward until the

DIN Rail clip tab engages and snaps to the bottom edge of the DIN Rail. Note

that the tab on the DIN Rail clip should always attach to the bottom of the DIN

Rail. Connect the external power supply to the rear of the installed media

converter.

Figure 6. Mounting/Dismounting Converter to/from DIN Rail

Dismounting from DIN Rail

To remove the converter assembly from the DIN Rail, hold the converter and

rotate upward to disengage the clip.

Mount

Dismount

1 2

Comments to this Manuals

No comments

Omnitron Systems Technology Universal DIN Rail Mounting Bracket 8250-0 User Manual Page 2

Comments to this Manuals

Related products and manuals for Network media converters Omnitron Systems Technology Universal DIN Rail Mounting Bracket 8250-0